SDS

A listing of SDS's
SAFETY DATA SHEET
Glutaraldehyde 1% and Paraformaldehyde 4% in 0.1M Phosphate buffer pH 7.4
1. IDENTIFICATION
Product Identifiers
Product Name:
Glutaraldehyde 1% and Paraformaldehyde 4% in 0.1M Phosphate buffer pH 7.4
Other Names:
Not available
Product Number(s):
15949-70, 15949-70-SP, 15949-80, CEMS15949-70, CEMS15949-80
CAS Number:
Not available.
Recommended use of the chemical and restriction on use
Laboratory Chemicals.
Company Details
ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia

(07) 4773 9444
www.proscitech.com
Emergency Contact Details
ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia

(07) 4773 9444
www.proscitech.com
2. HAZARDS IDENTIFICATION
Classification of the substance or mixture
GHS08 Health Hazard
Resp. Sens. 1 H334 May cause allergy or asthma symptoms or breathing difficulties if inhaled.
Muta. 2 H341 Suspected of causing genetic defects.
Carc. 1B H350 May cause cancer.
GHS07
Skin Irrit. 2 H315 Causes skin irritation.
Eye Irrit. 2A H319 Causes serious eye irritation.
Skin Sens. 1 H317 May cause an allergic skin reaction.
STOT SE 3 H335 May cause respiratory irritation.
Label Elements
Signal Words
Danger
Hazard Statement(s)
Hazard-determining components of labelling:
formaldehyde
Glutaraldehyde

Causes skin irritation.
Causes serious eye irritation.
May cause allergy or asthma symptoms or breathing difficulties if inhaled.
May cause an allergic skin reaction.
Suspected of causing genetic defects.
May cause cancer.
May cause respiratory irritation.
Precautionary Statement(s)
Obtain special instructions before use.
Do not handle until all safety precautions have been read and understood.
Avoid breathing dust/fume/gas/mist/vapours/spray.
Wash thoroughly after handling.
Use only outdoors or in a well-ventilated area.
Contaminated work clothing should not be allowed out of the workplace.
Wear protective gloves/protective clothing/eye protection/face protection.
Wear respiratory protection.
Primary route(s) of entry
Not available
Human Health
Inhalation:
Remove victim to fresh air and keep at rest in a position comfortable for breathing. If experiencing respiratory symptoms: Call a POISON CENTER/doctor.
Ingestion:
Get medical advice/attention.
Eyes:
Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
If eye irritation persists: Get medical advice/attention.
Skin:
Wash with plenty of water. Take off contaminated clothing and wash it before reuse.
If skin irritation or rash occurs: Get medical advice/attention.
Environment
Store in a well-ventilated place. Keep container tightly closed.
Store locked up.
Dispose of contents/container in accordance with local/regional/national/international regulations.
3. COMPOSITION/INFORMATION ON INGREDIENTS
Name
CAS No.
Content (w/w)
Classification
formaldehyde
50-00-0
>2.5-≤10%
Mixtures
Glutaraldehyde
111-30-8
≤2.5%
Mixtures
4. FIRST AID MEASURES
Ingestion
Call for a doctor immediately.
Inhalation
Supply fresh air and to be sure call for a doctor.
In case of unconsciousness place patient stably in side position for transportation.
Skin Contact
Immediately wash with water and soap and rinse thoroughly.
Eye Contact
Rinse opened eye for several minutes under running water. If symptoms persist, consult a doctor.
Other Information
Symptoms of poisoning may even occur after several hours; therefore medical observation for at least 48 hours after the accident.
5. FIREFIGHTING MEASURES
Suitable extinguishing equipment
Use fire extinguishing methods suitable to surrounding conditions.
HAZCHEM
No further relevant information available.
Special protective equipment and precautions for fire fighters
Mouth respiratory protective device.
6. ACCIDENTAL RELEASE MEASURES
Personal precautions, protective equipment and emergency procedures
Not required.
Environmental precautions
Inform respective authorities in case of seepage into water course or sewage system.
Do not allow to enter sewers/surface or ground water.
Methods and materials for containment and clean up
Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).
Dispose contaminated material as waste according to item 13.
Ensure adequate ventilation.
7. HANDLING AND STORAGE
Precautions for safe handling
Ensure good ventilation/exhaustion at the workplace.
Open and handle receptacle with care.
Prevent formation of aerosols.
Keep respiratory protective device available.
Conditions for safe storage
Keep container tightly sealed.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Exposure Standards
Material
TWA ppm
TWA mg/m3
STEL ppm
STEL mg/m3
formaldehyde
1ppm
1.2mg/m³
2ppm-
2.5mg/m³
Engineering controls
Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing.
Wash hands before breaks and at the end of work.
Store protective clothing separately.
Avoid Contact with the eyes and skin.
Personal protective equipment
Eye and face protection
Tightly sealed goggles.
Skin protection
Wear protective gloves. The glove material has to be impermeable and resistant to the product/the substance/the preparation.
The selection of glove material on consideration of the penetration times, rates of diffusion and the degradation. The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.
Body protection
Protective clothing.
Respiratory protection
In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use self-contained respiratory protective device.
9. PHYSICAL AND CHEMICAL PROPERTIES
General information
Appearance
Clear liquid
Odour
Fruit-like
pH
Not determined.
Vapour Pressure
23hPa
Density
Not determined.
Boiling Point
100°C
Melting Point
Undetermined.
Solubility
Not miscible or difficult to mix.
Specific Gravity of Density
Not available.
Flash Point
Not applicable.
Flammable (Explosive) Limits
Not determined.
Ignition Temperature
Product is not selfigniting.
Formula
Organic solvents: 4.0%
Water: 95.0%
VOC (EC): 4.0%
10. STABILITY AND REACTIVITY
Reactivity
No further relevant information available.
Chemical stability
No decomposition if used according to specifications.
Possibility of hazardous reactions
No dangerous reactions known.
Conditions to avoid
No further relevant information available.
Incompatible materials
No further relevant information available.
11. TOXICOLOGICAL INFORMATION
Acute effects
50-00-0 formaldehyde
Oral LD50 >200mg/kg (rat)
Eye contact
Irritating effect.
Skin contact
Irritant to skin and mucous membranes. Sensitisation possible through skin contact.
Ingestion
Not available.
Inhalation
Sensitisation possible through inhalation.
Toxicity and irritation
Harmful
Irritant
Carcinogenic
12. ECOLOGICAL INFORMATION
Ecotoxicity
No further relevant information available.
Persistence and degradability
No further relevant information available.
Bioaccumulative potential
No further relevant information available.
Other adverse effects
Harmful to fish.
Water hazard class 2: Hazardous for water.
Do not allow product to reach ground water, water course or sewage system.
Danger to drinking water if even small quantities leak into the ground.
Harmful to aquatic organisms.
13. DISPOSAL CONSIDERATIONS
General information
Must not be disposed together with household garbage. Do not allow product to reach sewage system.
Disposal must be made according to official regulations.
14. TRANSPORT INFORMATION
ADG label required
HAZCHEM
No further relevant information available.

UN Number
UN1760
Proper shipping name
1760 CORROSIVE LIQUID, N.O.S (Glutaraldehyde, FORMALDEHYDE SOLUTION)
Transport hazard class
8 Corrosive substances.
Packing group
II
Environmental hazard
Not applicable.
Special precautions for users
Warning: Corrosive substances.
Hazard identification number (Kemler code): 80
EMS Number: F-A,S-B
Segregation groups: Acids
Stowage Category: B
Stowage Code: SW2 Clear of living quarters.
Additional information
Limited quantities (LQ): 1L
Excepted quantities (EQ) Code: E2
Maximum net quantity per inner packaging: 30mL
Maximum net quantity per outer packaging: 500mL
15. REGULATORY INFORMATION
Poisons Schedule Number
50-00-0 formaldehyde S2, S6, S10
111-30-8 Glutaraldehyde S2, S5, S6
Other Information
Workers are not allowed to be exposed to the hazardous carcinogenic materials contained in this preparation.
Exceptions can be made by the authorities in certain cases.
A Chemical Safety Assessment has not been carried out.
16. OTHER INFORMATION
SDS preparation date
23 November 2023
Comments
The information is based on our present knowledge. However, this shall not constitute a guarantee for any specific product features and shallnot esablish a legally valid contractual relationship.
This Safety Data Sheet (SDS) has been prepared in compliance with the Preparation of Safety Data Sheets for Hazardous Chemicals Code of Practice February 2016. It is the user's responsibility to determine the suitability of this information for adoption of necessary safety precautions. The information published in this SDS has been compiled from the publications listed in Section 16: to the best of our ability and knowledge these publications are considered accurate. We reserve the right to revise Safety Data Sheets as new information becomes available. Copies may be made for non-profit use.

... End of SDS ...