SDS

A listing of SDS's
SAFETY DATA SHEET
Technovit® H7100 GMA Embedding Kit - Part 1
1. IDENTIFICATION
Product Identifiers
Product Name:
Technovit® H7100 GMA Embedding Kit - 7100 Liquid (Component of Kit C031)
Other Names:
TECHNOVIT 7100 - LIQUID
Product Number(s):
C031 1
CAS Number:
-
Recommended use of the chemical and restriction on use
Laboratory use.
Laboratory chemicals.
Company Details
ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia

(07) 4773 9444
www.proscitech.com
Emergency Contact Details
ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia

(07) 4773 9444
www.proscitech.com
2. HAZARDS IDENTIFICATION
Classification of the substance or mixture
GHS07
Skin Irrit. 2 H315 Causes skin irritation.
Eye Irrit.2 H319 Causes serious eye irritation.
Skin Sens. 1 H317 May cause an allergic skin reaction.
Label Elements
Signal Words
Warning
Hazard Statement(s)
Causes skin irritation.
Causes serious eye irritation.
May cause an allergic skin reaction.
Precautionary Statement(s)
Avoid breathing dust/fume/gas/mist/vapours/spray.
Wear protective gloves.
Wear eye protection / face protection. Wash thoroughly after handling.
Contaminated work clothing should not be allowed out of the workplace.
Primary route(s) of entry
Not available.
Human Health
Inhalation:
Not available.
Ingestion:
Not available.
Eyes:
Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do.
Continue rinsing.
Specific treatment (see on this label).If eye irritation persists: Get medical advice/attention.
Skin:
If skin irritation or rash occurs: Get medical advice/attention.
Wash with plenty of water. Take off contaminated clothing and wash it before reuse.
Environment
Dispose of contents/container in accordance with local/regional/national/international regulations.
3. COMPOSITION/INFORMATION ON INGREDIENTS
Name
CAS No.
Content (w/w)
Classification
2-hydroxyethyl methacrylate
868-77-9
50-100%
-
4. FIRST AID MEASURES
Ingestion
If symptoms persist consult doctor.
Inhalation
Supply fresh air and to be sure call for a doctor. In case of unconsciousness place patient stably in side position for transportation.
Skin Contact
Immediately wash with water and soap and rinse thoroughly.
Eye Contact
Rinse opened eye for several minutes under running water. If symptoms persist, consult a doctor.
Other Information
No further relevant information available.
5. FIREFIGHTING MEASURES
Suitable extinguishing equipment
CO₂, powder or water spray. Fight larger fires with water spray or alcohol resistant foam.
HAZCHEM
Not available.
Special protective equipment and precautions for fire fighters
No special measures required.
6. ACCIDENTAL RELEASE MEASURES
Personal precautions, protective equipment and emergency procedures
Not required.
Environmental precautions
Do not allow to enter sewers/ surface or ground water.
Methods and materials for containment and clean up
Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust). Ensure adequate ventilation.
7. HANDLING AND STORAGE
Precautions for safe handling
Ensure good ventilation/exhaustion at the workplace. Prevent formation of aerosols.
Conditions for safe storage
Keep container tightly sealed.
Store in a well-ventilated place. Keep cool.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Exposure Standards
Engineering controls
Store in a well-ventilated place. Keep cool.
Personal protective equipment
Eye and face protection
Tightly sealed goggles.
Avoid contact with the eyes and skin.
Skin protection
Protective gloves.
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/ the chemical mixture.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation.
Material of glove.s
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the application.
Penetration time of glove material.
The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.
Body protection
Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing.
Wash hands before breaks and at the end of work.
Avoid contact with the eyes and skin.
Respiratory protection
In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use self-contained respiratory protective device.
9. PHYSICAL AND CHEMICAL PROPERTIES
General information
Appearance
Colourless fluid
Odour
Characteristic
pH
Not determined.
Vapour Pressure
Not determined.
Density
1.1 g/cm³
Boiling Point
205 °C
Melting Point
Undetermined.
Solubility
Not miscible or difficult to mix with water.
Specific Gravity of Density
Not determined.
Flash Point
97 °C
Flammable (Explosive) Limits
Not determined
Ignition Temperature
Product is not selfigniting.
Formula
Not available.
10. STABILITY AND REACTIVITY
Reactivity
No further relevant information available.
Chemical stability
No decomposition if used according to specifications.
Possibility of hazardous reactions
No dangerous reactions known.
Conditions to avoid
No further relevant information available.
Incompatible materials
No further relevant information available.
11. TOXICOLOGICAL INFORMATION
Acute effects
The product shows the following dangers according to the calculation method of the General EU Classification Guidelines for Preparations as issued in the latest version:
Irritant.
Eye contact
Irritating effect.
Skin contact
Irritant to skin and mucous membranes.
Sensitisation possible through skin contact.
Ingestion
No further relevant information available.
Inhalation
Irritant to skin and mucous membranes.
Toxicity and irritation
LD/LC50 values relevant for classification:
868-77-9 2-hydroxyethyl methacrylate
Oral LD50 5050 mg/kg (rat)
12. ECOLOGICAL INFORMATION
Ecotoxicity
No further relevant information available.
Persistence and degradability
No further relevant information available.
Bioaccumulative potential
No further relevant information available.
Other adverse effects
Water hazard class 1 (German Regulation) (Self-assessment): slightly hazardous for water Do not allow undiluted product or large quantities of it to reach ground water, water course or sewage system.
13. DISPOSAL CONSIDERATIONS
General information
Must not be disposed together with household garbage. Do not allow product to reach sewage system.
Uncleaned packaging: ·
Recommendation: Disposal must be made according to official regulations.
14. TRANSPORT INFORMATION
ADG label required
HAZCHEM
Not available.

UN Number
None.
Proper shipping name
Not regulated.
Transport hazard class
Void
Packing group
None.
Environmental hazard
Not applicable.
Special precautions for users
Not applicable.
Additional information
No information available.
15. REGULATORY INFORMATION
Poisons Schedule Number
All substances have the value S5.
Other Information
No further relevant information available.
16. OTHER INFORMATION
SDS preparation date
17 August 2023
Comments
This information is based on our present knowledge. However, this shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship.
This Safety Data Sheet (SDS) has been prepared in compliance with the Preparation of Safety Data Sheets for Hazardous Chemicals Code of Practice February 2016. It is the user's responsibility to determine the suitability of this information for adoption of necessary safety precautions. The information published in this SDS has been compiled from the publications listed in Section 16: to the best of our ability and knowledge these publications are considered accurate. We reserve the right to revise Safety Data Sheets as new information becomes available. Copies may be made for non-profit use.

... End of SDS ...